Are grandfather clocks hard to set up and take down?
Grandfather clocks are very easy to set up and take down. When setting up the grandfather clock, you will first need to hook the pendulum on the suspension. The suspension spring will be hanging down below the movement. Next, put the weights on. Do not handle the weights with your bare hands, th ...
- Can the sound of the grandfather clocks be turned off anytime?
Yes, most grandfather clocks have a silence lever on the clock. Moving the lever to the silent position will allow the clock to keep time, but there will be no sound. When the clock is silent, the two outside weights will not drop, only the middle weight will drop. Most grandfather clocks also h ...
- How do you wind a grandfather clock?
Grandfather clocks need to be wound once a week. Depending on the kind of clock you have, you can wind the clock by pulling on the open end of the chains to lift the weights or for a cable-driven clock, use a crank to lift the weights up.
- How does a grandfather clock work?
A grandfather clock works by force of gravity. The force of gravity allows the weights to drop at a given pace. Each weight that is hanging has a different weight that allows different functions of the clock to work. One of the weights allows the pendulum to swing back and forth. The other weigh ...
- My clock does not cuckoo the right time.
Rotate the minute hand on the clock to the next hour. Let the clock cuckoo on the half hour every time you rotate the hands. Count how many times the clock cuckoos. Next move the hour hand to the number the clock cuckooed. The hour hand is on the shaft friction tight, if the hour hand feels lo ...
- My cuckoo clock is running fast or slow.
Remove the pendulum and move the pendulum disk down on the pendulum stick if the clock is fast. Push the disk up if the clock is slow. 1/16 inch will change the clock about 2 minutes per day. Be sure to set the correct time after each regulation. You may need to continue to make adjustments ...
- My cuckoo clock stops just before the hour.
This problem is a manufacturing defect. You would need to send the clock to us so a technician could solve the problem.
- My cuckoo clock will not cuckoo.
Make sure all the packing is out of the back of the clock. Open the back plate of the clock and pull out the orange clips on the bellows and check for packing around the chime rod. Look at the front of the clock and make sure the wire is not holding the bird door closed. If the wire is over the ...
- My cuckoo clock will not keep running it starts and stops.
Make sure the clock is level on the wall. The clock needs to be level front to back and side to side. Mark on your wall to indicate where your clock hangs level. It is level when the “Tick Tock” beat is perfectly even. You may have to tilt the clock a little to the left or right t ...
- The door for the bird on my cuckoo clock stays open.
Check the hinge of the door to make sure the hinge is not broken. Make sure the wire that holds the door closed is not stuck between the door and the bird. Take the clock off the wall and look into the back of the clock. There is a wire that sits under the bird’s tail. Make sure the wire i ...
- The music doesn’t work on my clock
Check to see if the clock has a lever to turn the music on and off. The lever may be on the bottom of the clock by the pendulum or on the side of the clock. The lever on the bottom of the clock is a push n pull lever. If the lever is on the side of the clock you can slide the lever up and down. ...
- What are the functions of the three weights?
Left Weight: This weight runs the strike/count of the clock. This weight allows the clock to count the time on the hour. Middle Weight: This weight allows the pendulum to swing back and forth which allows the clock to keep time. Right Weight: This is the heaviest weight. This weight runs the ...
- What is the difference between a cuckoo clock that has two weights and a cuckoo clock that has three weights?
A cuckoo clock that has only two weights does not play music, whereas a cuckoo clock that has three weights plays music.
- What is the difference between an 8 day cuckoo clock and a 1 day cuckoo clock?
An 8 day cuckoo clock will run a full week before the clock will need to be wound (See winding instructions for help on how to wind the clock). A 1 day cuckoo clock will run a full 24 hours before the clock will need to be wound. Another difference between the clocks is the size of the weights ...
- What is the pendulum used for?
The pendulum is what is running the clock and keeping accurate time. The pendulum bob can be adjusted up or down to adjust the time to run faster or slower. Remove the pendulum and move the pendulum disk down on the pendulum stick if the clock is fast. Push the disk up if the clock is slow. 1/1 ...
- What is the warranty charge for?
The warranty charge is to cover shipping and handling. If the clock is still under warranty the warranty charge covers any and all work that needs to be done to the movement of the clock. The warranty does not cover any damage to the wood or carvings on the clock.
